Aluminum Alloy Grille Panel

Name: Aluminum Alloy Grille Panel
Brand: Huahong
SKU: 449
Rating: 5.0 (1 reviews)

This page is for raised floor areas that need high airflow and can use an open grille panel without a top veneer. Huahong’s Aluminum Alloy Grille Panel provides up to 50% airflow and can be interchanged with blind panels and ventilation panels in the same floor system, so it can be placed where underfloor air needs to move upward while other areas keep solid or perforated panels. Because the top surface is an open grille, no veneer can be attached to it. The whole panel can be finished with conductive epoxy powder or nickel-chromium coating for corrosion and wear resistance, and the conductive epoxy powder also supports conductive performance. The panel is available in AL300, AL500, AL700 and AL1000 grades, with concentrated loads of 300, 500, 700 and 1000 kgf/6.45 cm² respectively. Send the required model, airflow rate, coating option, quantity and destination port for a project-specific quotation within 24 hours.

Send Inquiry

Rating: 5.0

(Rating Count: 1)

Product Description

Product Introduction

The Aluminum alloy grille panel can achieve a high airflow rate of up to 50% and can be interchanged with blind panels and ventilation panels. Compared to blind panels and ventilation panels, the panel cannot have any veneers attached to the top. The entire panel can be coated with conductive epoxy powder or nickel chromium coating, which has good corrosion resistance and wear resistance. Conductive epoxy powder can also help the panel achieve conductive function.

Product Specifications

model	Concentrated load(deflection≤2.0mm)	ultimate load	uniformly distributed load(deflection≤1.0mm)	Rolling load
AL300	300kgf/6.45cm²	600kgf/6.45cm²	800kgf/m²	50kgf
AL500	500kgf/6.45cm²	1000kgf/6.45cm²	1250kgf/m²	100kgf
AL700	700kgf/6.45cm²	1400kgf/6.45cm²	1700kgf/m²	150kgf
AL1000	1000kgf/6.45cm²	2000kgf/6.45cm²	2000kgf/m²	250kgf

Suggestions for the Use Maintenance

Cleanliness requirements for the venue

Due to strict cleanliness control requirements during the construction of the purification workshop, in order to avoid the omission and residue of dust particles, which may affect the future use of the purification workshop, all floors in the factory must be washed clean with an air compressor first, and then packaged in plastic bags before being transported into the workplace. Construction personnel must change into specialized work clothes, work shoes, hats, and gloves for the purification workshop before entering the site. Floor cutting must have a separate room to ensure a clean and safe working environment.

Equipment installation requirements

When the equipment is directly placed on the aluminum alloy floor, a stainless steel plate with a size of 150 * 150 mm or larger and a thickness of 5mm~10mm must be used to pad the foot of the equipment and expand the contact surface with the floor. When the equipment is heavy or has anti vibration requirements, it is usually necessary to build an independent foundation (steel platform or poured concrete platform) for the equipment, and the floor installation should be separated from the equipment platform.

Equipment handling requirements

Plan the equipment transportation route in advance and designate the area as the equipment transportation channel. The floor surface at the transportation channel must be protected with 3mm-5mm stainless steel plates. When moving and transporting equipment on the floor, it is strictly prohibited for the equipment to roll and roll directly on the floor. Hydraulic vehicles with larger wheel diameters should be selected as transportation tools as much as possible. In transportation engineering, strive to move equipment at a constant speed to avoid impact on the floor.

Related Category